© 2010 American Honda Motor Co., Inc. – All Rights Reserved.
AII 44367 (1008)
5 of 28
3.
Touch the metal part of the screwdriver to any metal
part of the vehicle to discharge any static electricity.
4.
Check the settings of the switches on the control
unit.
NOTE:
•
The switches must be set before the control unit
is plugged in.
•
If the switch settings are not correct, the remote
engine starter will not operate correctly.
•
If you change the switch settings with the unit
connected, you must disconnect the unit, then
reconnect it before the control unit recognizes
the new settings.
5.
Using a small flat-tip screwdriver, adjust the switches
on the control unit as shown.
921301AD
CONTROL
UNIT
SMALL FLAT-TIP
SCREWDRIVER
Discharge any
static electricity.
SET
SWITCHES
SWITCHES
SW:1 RR Junction unit -------------------- > OFF
SW:2 Trunk or Tailgate -------------------- > ON
SW:3 Smart Entry --------------------------- > OFF
SW:4 Horn or Buzzer Answerback ---- > OFF
SW:5 Trunk Main SW ----------------------- > OFF
SW:6 Reserve--------------------------------- > OFF
6.
Using isopropyl alcohol on a shop towel, thoroughly
clean the area where the protective tape will attach.
Remove the backing from the protective tape. Attach
the protective tape to the control unit over the
switches.
Removing the Vehicle Parts
7.
Remove the right and left map light lenes (four
retaining tabs each). Do not damage the lenses.
772505AS
CONTROL
UNIT
SWITCHES
PROTECTIVE
TAPE
BACKING
Clean.
802001AD
RIGHT MAP
LIGHT LENS
4 RETAINING
TABS
LEFT MAP
LIGHT LENS
PLASTIC TRIM
TOOL
ROOF CONSOLE
4 RETAINING
TABS
