HONDA marine BF115J, Owner'S Manual

Page: 74 / 170

73
STARTING THE ENGINE
The power will not be turned ON
unless the Honda Smart Key is
authenticated.
4. Push the start/stop switch.
When the boat is mounted with the
two outboard motors, push the all
engine start switch.
• The starter motor consumes a
large amount of current. Do not
therefore run it continuously for
more than 5 seconds at a time. If
the engine does not start within 5
seconds, wait at least 10 seconds
before running the starter motor
again.
5. After starting, check whether the
cooling water is flowing out of the
cooling water check hole. Amount
of water flowing out of the check
hole might vary due to the
thermostat operation, but this is
normal.
If water does not flow out, or if
steam comes out, stop the engine.
Check to see if the screen in the
cooling water intake port is
obstructed and remove foreign
materials if necessary. Check the
cooling water check hole for
clogging. If water still does not flow
out, have your outboard motor
checked by an authorized outboard
motor dealer. Do not operate the
engine until the problem has been
corrected.
COOLING WATER CHECK HOLE
COOLING WATER INTAKE PORT
(each side)
32ZVT600.book 73 ページ ２０２１年１０月１５日 金曜日 午後４時９分