INTRODUCTION
The SANO PIV Wall is a positive input ventilation unit suitable for installation on a wall for dwellings without a loft space. It continuously supplies
fresh air through a discharge diffuser, that should be situated in the central hallway or landing. The unit has multiple options for the inlet spigot; on
both sides and the back of the unit allowing multiple installation options. The unit can also be configured to discharge air from the left or right hand
side.
WHAT IS IN THE BOX
1. Ventilation unit
2. Filter (pre-fitted)
3. Installation Manual
4. Installer label
5. Blank panel (if back inlet used)
6. Side panel with outlet grille for use as required
TECHNICAL SPECIFICATIONS
•
Outer fan casing manufactured from pre-coated galvanised sheet steel providing a lightweight construction.
•
An ultra-quiet EC motor/fan assembly for energy saving, mounted on ball bearings that guarantee a longer product life and is suitable for cold
climates.
•
G2 filter fitted as standard with large surface area to provide long filter life and efficient filtration of incoming air.
•
All fans are individually tested before leaving the factory and are designed and manufactured to procedures defined in BS EN ISO 9001:2015.
•
Power Supply 230V – 50/60Hz.
Power W max
Sound pressure dB(A) @3m
28
27
Unit setting
Inlet grille (5m duct 2x bends)
Outlet grille
Flow Rate
Watts
Flow Rate
Watts
1
13
3.7
14
4.5
2
17
4.8
17
5.2
3
21
6.4
21
6.9
4
25
9.2
25
9.3
5
29
11.1
29
12.7
6
33
16.8
34
16.8
The power consumption shown is Normal mode.
INSTALLATION
Duct work should be kept as simple as possible minimising duct length and the number of bends. This will optimise the unit’s effectiveness. Ducting
from the external to the unit should be kept as short as possible as condensation can form on the cold ductwork if it is not insulated.
The unit comes fitted with round 100mm spigots for easy fitment of round rigid ducting. If rectangular 110x54 ducting is required a rectangular to
round adaptor can be fitted directly to the spigot. To do this the spigot must be cut to 25mm length.
Enough room needs to be allowed to access the screws for maintenance.
The diffuser or grille supplying air into a home should be fitted a minimum of 1000mm away from a central heating thermostat.
The diffuser or grille supplying air into a home should be fitted a minimum of 1000mm away from any smoke or CO detectors. If this is not possible
seek specialist advice.
If the property is, or is part of a building that has a storey 18m or above ground level, additional careful design consideration is required due to the
complex nature and health and safety implications of such installations. If considering a PIV unit installation in such a property, seek specialist advice.
