Homeright PaintStick, Instruction Manual

Page: 4 / 20

4 PAINTSTICK
®
ENGLISH
4.
Remove roller frame by
unscrewing nut on end of roller
frame.
6.
Place PaintStick into clean
warm water and flush fill port
by plugging end of PaintStick
with finger and pulling inner
handle back and pushing forward
several times.
• NOTE: For best performance, also
clean Fill Tube.
7.
Separate inner and outer
handles by quickly pulling apart.
•
NOTE:
If you cannot separate,
set PaintStick on floor, put your
foot on collar and roll to loosen.
NOTE:
If painting with
an oil based paint
use manufacturer’s
recommended cleaning
solvent instead of warm
water in the following
steps. Follow manufacturer’s
directions for using mineral
spirits and disposal.
1.
Return paint from PaintStick to
paint can by holding PaintStick
at a 45° angle and push
PaintStick fill port onto fill tube
until it bottoms on fill tube.
Push inner handle in until it
stops.
2.
Remove paint from roller
assembly by holding finger over
fill port and pulling inner handle
back. Repeat previous step.
3.
Clean PaintStick by submerging
PaintStick in warm water so
the roller cover and fill port are
covered. Pull inner handle back
and push forward several times.
Cleaning and Disassembling the PaintStick
5.
Insert paint can cover and fill
tube into PaintStick fill port.
Place in warm water and flush
fill tube by pulling inner handle
back and pushing forward
several times. Remove paint
can cover and fill tube from
PaintStick.
8.
Depress the PUSH TO REMOVE
tab. It will snap to remove the
outer end cap.