ZIR000 Instructions, Release 1.1
P/D 110805
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0685-01
4
WAKEUP COMMAND CLASS
The ZIR000 will send a Wakeup Notification Command approximately 3 minutes after power up IF and only IF
it has been included into a Z-Wave network. From that point on, the ZIR000 will wake up every 4 hours and
re-send the Wakeup Notification Command unless configured for another time interval. The ZIR000 will stay
awake by default for 30 seconds and then go back to sleep to conserve battery life.
The time interval between Wakeup Notification Commands can be adjusted if you have a device that supports
this. Refer to that device’s instructions.
The time the ZIR000 stays awake can be adjusted from 15 seconds to 45 seconds by sending a value of 15
to 45 to the ZIR000 using Configuration Parameter # 22. This time starts over every time the ZIR000 receives
a command or request.
NTEROPERABILITY WITH Z-WAVE™ DEVICES
A Z-Wave™ network can integrate devices of various classes, and these devices can be made by different
manufacturers. The ZIR000 can be incorporated into existing Z-Wave™ networks.
The “button” inside the cover of the ZIR000 can be used to carry out inclusion, association, or exclusion.
SPECIFICATIONS
Power
Four (4) AAA batteries
Mounting
Mounting bracket provided
Signal (Frequency)
908.42 MHz
Range
Up to 100 feet line of sight between the Wireless Controller and /or the
closest HomePro Receiver Module
Mounted Dimensions (H x W x D)
4.125” x 2.6” x 3.10” (10.47cm x 6.6cm x 7.8 cm)
WARRANTY
For warranty and general product information visit our web site at www.act-solutions.com
ABOUT ZIR000’S CERTIFICATION
The ZIR000 is also certified to comply with applicable FCC and IC
rules and regulations governing RF and EMI emissions.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation.
FCC NOTICE
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures:
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.
IC NOTICE
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
