HOMEPIN Spinal Tap Pinball, Service Manual

Page: 13 / 55

Homepin Taiwan Company Limited
J15 – J16 – J27 connections
INC: Direct switches
This is Spinal Tap Pinball (TAP)
12
th
April 2022
Connectors on H-0012 interconnect PCB
J27 – Flipper connection
P1 – Flipper mute signal to flipper boards white
P2 – Left Flipper OUT, drive to flipper PCB (to IN on flipper PCB) blue/white
P3 – Right Flipper OUT, drive to flipper PCB (to IN on Flipper PCB) yellow/white
KEY
P5 – Left Flipper IN from flipper control PCB (from OUT on flipper PCB)
blue
P6 – Right Flipper IN from flipper control PCB (from OUT on flipper PCB) yellow
P7 – Launch Warn signal IN from H-0106 (5 opto board) VIA flipper board pink
J16 - Cabinet
P1 – Left Flipper IN from flipper opto board (cabinet push button) blue
P2 – Right Flipper IN from flipper opto board (cabinet push button) yellow
P3 – 5V N/C
P4 – Tilt IN from plumb bob green
P5 – Menu (switch on door PCB) orange/white
P6 – Enter (switch on door PCB) grey
J15 - Cabinet
P1 – Coin ONE IN (optically isolated – usually from coin mech etc) purple
P2 – Coin TWO IN (optically isolated – usually from coin mech etc) purple/white
P3 – Door (Ball launch button) (NOTE: Not used in TAP) N/C green/white
P4 – Start IN (front cabinet button game start button) black/white
P5 – Start Lamp OUT (LED mounted inside start button) red/white
P6 – 5V red
P7 – Ground black
13