HOMEPIN Spinal Tap Pinball, Service Manual

Page: 8 / 55

8
Battery isolation strip
Menu/Auto toggle
Speaker LED effect operation (if installed)
Toggles LEDs on/off
Pull down to remove and activate remote
This is a radio system not infra-red so it is not necessary
Adjusts the number of LED pixel points & the RGB order
In the OFF state, press & hold MENU for 5 seconds to enter setup menu
Press mode + and mode - to adjust the number of LED pixel points
Press the RGB button to adjust the RGB order
Press the R button until the LED strip shows RED
Press the G button until the LED strip shows GREEN
Press the B button until the LED strip shows BLUE
Press the power on/o ffbutton to exit programming mode
to point the remote at the receiver for it to operate
Press & hold “G” for 5 seconds
LED strip will flash GREEN 3 times
when paired
to pair TX to RX
Press & hold “W” for 5 seconds
LED strip will flash WHITE 3 times
when no longer paired
to un-pair TX & RX
Also used to save a manually set parameter
Mode advance (358 presets)
Mode backwards (358 presets)
Speed & Brig
Red/Green/Blue/White only
Adds current effect to
Removes current effect from
the custom mode
the custom mode
Speed & Brightness -
Custom mode -
Custom mode +