Testing the door
Disable all locks and remove any ropes connected to
the garage door.
Complete the following test to ensure your door is well
balanced, and not sticking or binding:
• Lift the door to about halfway and then release it. The
door should remain suspended entirely by its spring.
• Raise and lower the door to discover if there are any
sticking or binding points.
• If your door spring does not hold the door in place or the
door binds or sticks, call a qualified door technician before
automating the door.
• Install stop bracket collar on the opposite end to where
the opener is to be installed.
• Fit the stop bracket hard against the boss of the door
drum. Ensure the U-bolt holding the door shaft to the door
bracket is tightly secured.
Installing the stop collar
5
• Place the weight bar in the centre of the door.
• Use a Pencil to mark the two hole positions.
• Drill two 5.5mm holes through the two marked position,
then place the weight bar on the inside of the door.
• Use the 5mm bolts, washers and nuts (provided) to
fasten the weight bar in place.
Installing the weight bar (provided)
6
SAFETY CHECK!
Is your door balanced?
YES (proceed to the
next step)
NO (Contact a garage
door service technician
before proceeding).
SAFETY CHECK!
Is stop collar installed?
YES (proceed to the
next step)
NO (install the stop collar
before proceeding).
Non motorised side
4
4
Summary of Contents for HE60R
Page 2: ...0 ...
