10
www.homewerksww.com
EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS
6. Mount fan housing to the joist or stud using long
+/ $ ':
outside fan housing.
Hardware Used
AA
Long wood screws
x 2
7. Replace duct connector by hooking the connector
* $ & " " $
fan housing and then pressing down on the other
side to snap the connector into place. Ensure
$ && * & " $ * $"
are inside the plastic duct connector when it is
replaced.
8.
Pull the house wires through the wire box cover
hole. Using a quick connector, secure 120 V
AC house wiring from the wall switch to the fan
$ $ " " "
AWB is the smallest conductor that should be
used for branch-circuit wiring. Please refer to
the wiring diagrams for detail on page 5.
Carefully push the connect wires back into the
wiring box housing. Reattach the wiring box
cover.
CAUTION:
If your electrical wires do not match
the colors listed, you must determine what each
house wire represents before connecting. You
may need to consult an electrical contractor to
determine safely.
9.
J&& & + &/
$ & +$
&/
Finish ceiling work. Ceiling hole should be aligned
with edge of the fan housing.
6
8
9
Product
wires
House
wires
Quick
connector
7