43
Registering/teaching another additional remote control/button pair:
Press the top button "Unlock" for approx. 2 seconds, to start the teach
process.
The LC display shows "X", the symbols for radio reception and
"Unlock"flash (aborting the teach process is possible as described above).
Now, press any button on the "Master" remote control, that is already
assigned to the KeyMatic, until a free memory location is shown instead of
"X", e.g. "2".
The device LED of the master remote control is illuminated in red when
authenticating!
In order to teach another button pair or a single button, set the remote con-
trol to configuration mode and briefly press one of the buttons of the button
pair or respective button to be taught.
Button pairs that are configured as “OFF/ON” buttons are taught with the
Lock/Unlock functions and a long press on the “ON” button will also open
the door.
To teach another remote control/button(pair), start again from the beginning.
The next free memory location appears (from 1-K). If there is no free memory
location, an error message ("FULL") appears on the LC display and the
menu is aborted.
Up to 30 buttons on up to 20 different remote controls can be taught. The
memory location shown on the display of the door lock drive symbolizes a
remote control. If more buttons(pairs) of a remote control have been taught,
this is also only shown with one memory location (for the remote control).
We recommend that you mark the remote controls, e.g. write a number or a
letter inside the battery compartment cover.
If you pass the remote controls to a certain person, labeling remote control
with the assignment is a good idea (who has which remote control). If lost,
the right remote control can be blocked simply and quickly (more precisely,
the memory location & the assignment of the remote control is deleted in
the door lock drive). The master remote control is recognized immediately
when operating by the “1” that appears on the KeyMatic display.
The "Master" remote control should not be given to anyone else, since only
this remove control can be used for registering or deleting other remote
controls!
If the "Master" remote control is lost (or is defective), proceed according to
chapter 7.3.2 to replace it.
Summary of Contents for KeyMatic HM-Sec-Key
Page 50: ...50...
Page 51: ...51...
Page 52: ...52 eQ 3 AG Maiburger Stra e 29 D 26789 Leer www eQ 3 com...
