54
55
6.1 Teaching-in
Please read this entire section before starting
the teach-in procedure.
To integrate the actuator into your HomeMatic system
and enable it to communicate with other HomeMatic
devices, you must teach it in first. You can teach-in the
device directly to other HomeMatic devices or to the
HomeMatic Central Control Unit:
6.1.1 Teaching button inputs to actuator channels
If you would like to teach-in the actuator to one or
more HomeMatic devices, you must put the devices to
be taught-in into teach-in mode and select the required
teach-in channel. To do this, proceed as follows:
The button inputs are not assigned to any actu-
ator channels in factory status (not the actuator
channels of the device on which they are loca-
ted either)
Assignment of button inputs to actuator channels
•
Press the programming button of the actuator
(channel) to be assigned on the module until the
channel LED flashes slowly (after approx.
3 seconds). The module is now in teach-in mode.
•
Now, actuate a button on the button input (on the
same module or any other module on the bus) that
you want to assign to the actuator (channel).
•
The actuator (channel) is now assigned with this
switch input and the channel LED goes dark on the
actuator.
•
Test the assignment by pressing the respective
button. The actuator (channel) should react
according to the configuration of the button input.
•
If you want to assign another button input to the
actuator (channel), repeat this procedure.
Depending on the actuator, button inputs are taught-in
differently:
Actuator
Button behavior
Switch actua-
tor, Dimming
actuator
Taught-in buttons behave like
toggle switches
