39
Replacing batteries
trol, please proceed as follows:
• Once mounted, the remote control can easily be
pulled out of the frame
(A)
or removed from the
mounting plate
(F)
. To remove the remote control
(B)
from the frame, take hold of the sides of the
remote control and pull it out
(see figure 5)
. You
do not need to open the device.
• Turn the remote control over to remove the bat-
teries.
• Insert two new 1.5 V LR03/micro/AAA batteries
into the battery compartment, making sure that
you insert them the right way round
(see figure 6)
.
• Put the remote control back into the frame. Make
sure that “TOP” and the arrows on the back side
point upwards and that the clips on the mount-
ing plate latch into the openings on the remote
control.
• Please pay attention to the flashing signals of the
device LED while inserting the batteries (see „7.4
Error codes and flashing sequences“ on page
42.
Once the batteries have been inserted, the wall-mount
remote control will perform a self-test (approx. 2 sec-
onds). Afterwards, initialisation is carried out. The LED test
display will indicate that initialisation is complete by light-
ing up orange and green.
