HomeMatic HM-LC-Sw1-DR, Installation And Operating Manual, Page: 55 / 76

55
Start-up
Before being able to use and configure your device in
the Homematic system to control connected loads, the
switch actuator has to be taught-in first (see sec. “6.2
Teaching-in” on page 55).
6.2 Teaching-in
Please read this entire section before starting
the teach-in procedure.
6.2.1 Teaching-in directly to Homematic devices
If you want to teach-in the switch actuator to one or
more Homematic devices, the teach-in mode of both
devices has to be activated first. To do this, proceed as
follows:
During teach-in, please make sure you maintain
a distance of at least 50 cm between the devices.
Activate the teach-in mode of your switch actuator.
• Therefore, press and hold the device button
(A) for
at least 4 seconds. The device LED (B)
will flash
slowly to indicate that teach-in mode is active. The
teach-in time is 20 seconds.