8
9
About White Dust:
Use of high mineral content hard water may cause a white mineral residue to accumulate on
surfaces in the room near the humidifier. The mineral residue is commonly called “white dust.”
The higher the mineral content (or, the harder your water is), the greater the potential for white
dust. The white dust is not caused by a defect in the humidifier. It is caused only by minerals
suspended in the water.
How and Why To Use Demineralization Cartridges:
The HoMedics demineralization cartridge will help reduce the potential for white dust, a deposit
of minerals left behind from using hard water in your humidifier. The cartridge should be replaced
every 30 – 40 fillings. The cartridge may need to be replaced more often if you are using very
hard water. Replace the cartridge when you notice an increase in white dust build-up. If white
dust still forms around the humidifier after a new cartridge has been installed, consider using
distilled water. To purchase new demineralization cartridges, model # HUM-HDDC4-6CTM, go
back to the retailer (where you purchased your humidifier), or visit www.homedics.com
If you live in an area with hard water, or use a water softener, we recommend using
distilled water for better results from your humidifier. Never use water softening
additives in your humidifier.
Installing Instructions
1. Remove demineralization cartridge from packaging and let it soak
in water for 10 minutes.
2. Remove the tank from humidifier base. (Fig. 3)
3. Place the soaked demineralization cartridge into the matching slot
in the humidifier base. (Fig. 9)
4. Place the tank back on the base, making sure the tank is firmly
seated. (Fig. 7)
Note:
Demineralization cartridge has no top or bottom. Either side can
face upward.
Cleaning and Care
CAUTION:
Before cleaning the unit, turn power off and unplug unit
from the outlet.
Tank Cleaning
Remove the water tank from the humidifier base by lifting it
from the main unit. Unscrew the tank cap and rinse inside the
tank with clean water. To remove any scale or build up, use
a 50/50 mixture of vinegar and lukewarm water to clean the
inside of the tank.
Suggestion:
Clean the water tank once every two to three
weeks, depending on your water conditions.
To Clean the Ultrasonic Membrane:
Put a small amount of mild dish soap on the surface of the
ultrasonic membrane, then pour in some water and soak for 5
minutes. Brush clean with soft bristle brush (not included) and
rinse. (Fig. 11)
Suggestion:
Clean the membrane once every two to three
weeks, depending on your water conditions.
NOTE:
Never submerge the base in water or any liquid.
Surface Cleaning
Clean the surface of the unit with a clean damp soft cloth as
often as needed. (Fig. 12)
Fig. 12
Fig. 11
Fig. 8
Fig. 9
Fig. 10
