![HoMedics FacialSpa ULTRA FAC-200 Instruction Manual And Warranty Information Download Page 4](http://html.mh-extra.com/html/homedics/facialspa-ultra-fac-200/facialspa-ultra-fac-200_instruction-manual-and-warranty-information_2152587004.webp)
To Use the Pore Refiner suction attachments:
For safe use, always follow these Safety Guidelines:
•
DO NOT hold suction cup in one area for more than 2 seconds at a
time. Apply the cup and remove quickly to avoid purple spots or
skin discoloration.
•
Use small suction cup only in the nose area and the large suction
cup for the cheeks, forehead, and chin.
•
Limit the length of time you use on your face – up to 1 minute
around nose area and 4 minutes in the cheeks, forehead, and chin.
•
DO NOT use around and between your eyes, head, hairline, or on
areas where skin is relatively thin.
•
DO NOT use on pimples, blemishes, sunburned or broken skin, or
inflamed areas.
•
If you have sensitive skin, DO NOT use more than twice in the
same area.
1. Select the desired attachment to begin your deep pore cleansing.
• Large Suction Cup – Removes impurities deep below the skin’s
surface around the forehead, chin, and cheeks
• Small Suction Cup – Removes impurities below the skin’s sur-
face around the nose
2. Secure the attachment to the facial unit.
3. Select your desired speed – LO for gentle suction and HI for more
suction.
4. Apply the small suction cup attachment to cleanse the nose area.
5. First dampen the nose area, then apply the suction cup. Work area
for approximately 1 minute. Do not hold in one area for more than
2 seconds.
6. Apply the large suction cup to cleanse the cheeks, chin, and fore-
head areas.
7. Work around these areas for approximately 4 minutes. Move from center
of face to sides. Do not slide across face. Lift up with a slight twist and
move to next area.
8. Mist your face to close your pores. Then rinse your face and apply moisturizer.
9. When finished, turn the unit off and remove and rinse the attachment.
10. Place facial unit back into the charging base for storage.
To Use Mist Feature:
1. Pull back tab on the mist chamber (Fig. 3)
2. Place chamber under a narrow stream of running water.
NOTE: Do not allow unit to be heavily immersed or submerged in water.
3. Close tab.
4. Press the mist button (Fig. 1) to dispense a cool gentle mist.
6
7
Figure 2
Figure 3
Mist
Chamber
FAC-200 10/6/03 3:24 PM Page 7