28
NOTE:
If the unit still does not work, contact HoMedics Consumer Relations.
Under no circumstance should you disassemble or attempt to repair
the unit by yourself. Contact HoMedics Consumer Relations at
the number listed in the Warranty section.
SYMPTOMS
POSSIBLE
CAUSES
CORRECTION
Unit does not
turn on when the
“START/STOP”
button is pushed.
Batteries have
run down.
Replace them with
2 new “AAA” alkaline
batteries.
Battery polarities
have been positioned
incorrectly.
Reinsert the batteries in
the correct positions.
EE measurement
error symbol shown
on display or the
blood pressure
value is displayed
excessively low
(or high).
Cuff has been placed
incorrectly.
Wrap the cuff properly
so that it is positioned
correctly. Measure again.
Did you talk or
move during
measurement?
Keep wrist steady
during measurement.
Measure again.
Shaking of the wrist
with the cuff on.
E1 error symbol
shown on display.
Air circuit
abnormality.
Measure again.
E2 error symbol
shown on display.
Inflation pressure
exceeding 300 mmHg.
Switch the unit off, then
measure again.
E3 error symbol
shown on display.
Error determining
measurement data.
Rewrap the cuff properly
so that it is positioned
correctly. Take new
measurement.
EP error symbol
shown on display.
System error.
System Error: Turn off
monitor and measure
again. If EP error still
appears on the display,
please call a Consumer
Relations representative.
TROUBLESHOOTING
If any abnormality arises during use, please check the following points:
