DATE & TIME SET PROCEDURE
1. Slide the “On/Off” Switch located on the back
of the monitor into the “On” position.
2. To adjust the date/time, press the
Set button
,
located on the back of the monitor.
3. The display will show a blinking number showing
the month. Change the month by pressing the
button
. Each press will increase the number by one
in a cycling manner. Press the
Set button
again
to confirm the entry, and the screen will show a
blinking number representing the day of the month.
4. Change the date and time as described in Step 2
above, using the
button
to change the num-
bers and the
Set button
to confirm the entries.
5. A “0” will reappear as the blood pressure monitor is
ready for measurement again.
USING THE AC ADAPTER
Note:
• Please unload the batteries from the battery
pack when operating with the AC adapter for
an extended period of time. Leaving the batter-
ies in the battery pack for a long time may
cause leakage, which may lead to damage
of the unit.
• No batteries are needed when operating with
the AC adapter.
1. Remove the battery pack by pressing down on the
latch and pulling away from the monitor.
2. Connect the AC adapter with the AC adapter jack
in the back of the unit as shown below.
3. Please use only the AC adapter included with
this monitor.
13
Press the button
blinking month
increasing month
confirm the entry
repeat process to set date and time
14
AC Adapter
Input: 120V 60Hz
Output: 12V DC 500mA
Connect AC
adapter here
