Installing the batteries
□
□
□
Learning process
Should you desire to use another remote control unit with your
new fan, install one using the steps below:
□
Return the power to the unit.
Within 60 seconds of turning the fan's AC power ON, once the
receiver has detected the set frequency, the down light of your
fan, if applicable, will blink twice. There is no indication if your
fan is not equipped with a light.
□
A receiver can remember up to three remote controls, when
the fourth is used, the first would be deleted.
□
NOTE: After the AC power is on, do not press any other button on
the remote control before pressing the “FAN OFF” button. Doing
so will cause the procedure to fail.
NOTE: The remote control can learn multiple receivers. Make sure
no other receivers are operating during the learning process.
Separate the fan power switches by approximately 7 meters.
□
Press and hold the button for 5 seconds to enter the learning
function.
□
NOTE: The battery will weaken with age and should be replaced
before leaking takes place as this will damage the remote
control. Dispose of used battery properly and keep the battery
out of the reach of children.
Remove the battery cover by pressing on the arrow
andsliding the cover off.
Install two 1.5V AAA batteries (S).
Replace the battery cover on the remote control.
CAUTION: Do not use with a wall light dimmer switch.
Turn the main power source off to begin the learning process.
13
Item # 1000*****/1000*****
Item # FC132-BJRL/FC140-BJRL
Operation
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
