Assembly - Hanging the Fan
Attaching the fan to the electrical
box
Hanging the fan
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Install the ceiling mounting plate on the outlet box by the
mounting bracket (A) over the two screws (AA) provided with the
outlet box (M) . If necessary, use leveling washers (not included) be
-
tween the mounting bracket (A) and the outlet box. Note that the
□
Securely tighten the two mounting screws (AA) (not included).
3
4
WARNING:
or other personal injury, mount the fan to an outlet
box or supporting system marked acceptable for fan
support and use the mounting screws provided with
the outlet box.
WARNING: The hook (XX) is only to balance the fan while
making the electrical connections. Failure to hang as shown
may result in the hook (XX) breaking, causing the fan to fall.
The hook must pass from the inside to the outside of the
canopy.
WARNING: When hanging the fan on the hook (XX) it is
critical that you use one of the non-slotted (round) holes in
the canopy (C).
□
Carefully lift the fan-motor assembly (F) up to the slide-on
mounting bracket (A).
□
Insert the ball portion of the ball/downrod assembly into
the socket of the slide-on mounting bracket (A).
□
Turn the ball/downrod assembly clockwise until it is seated
with the tab of the slide-on mounting bracket (A) aligned
with the slot in the ball.
8
