6
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
FCC Statement
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Care and Cleaning
Clean the light fixture carefully with a soft, dry cloth. Do not use any cleaners with chemicals, solvents, or
harsh abrasives.
Troubleshooting
Install the canopy (B) over the universal crossbar (EE)
and tighten the two ball nuts (FF) to the mounting
screw (DD).
Installation (continued)
4
Installing the canopy
EE
FF
DD
B
The bulb is burned out.
Replace the light bulb.
The power is off.
Ensure that the power supply is turned
on.
Ensure that the circuit breaker is set to
the ON position.
Unplug the other items on the circuit.
call the Customer Service Team at
1-800-986-3460.
The circuit breaker is off.
There are too many items on
one circuit.
The bulb will not light.
The fuse blows or the circuit
breaker trips when the light
is turned on.
Problem
Possible Cause
Solution
Contact a qualified electrician or
