If the connection is unsuccessful, “Connection Failed” will be displayed. Check the
controller’s IP address, port setting, and encryption key.
5.
If an HAI controller is not being used, press the [Off] button under “Controller”. This can
be used if you are using an OmniTouch 5.7e to communicate with an HTX Home Theater
Extender, but are not connecting to or do not have an HAI controller.
After all controller connection parameters have been entered or confirmed, press the “Screen
Setup” tab to configure various operating parameters of the OmniTouch 5.7e or press the [OK]
button at the bottom of the page to save the settings and connect to the HAI controller.
Screen Setup
The Screen Setup page allows you to configure the Volume, Sounder, Key Click, Brightness,
Backlight Timeout, and Ambient Light settings of the OmniTouch 5.7e. The Screen Setup page
also allows you to calibrate the touchscreen and displays the version of the installed firmware.
Volume :
Sets the volume for the sounder and key click.
Sounder:
Enables or disables the touchscreen sounder. The sounder is used
to alert you of errors, troubles, and messages, and emits tones upon
entry and exit delays.
Key Click:
Enables or disables key clicks (a short tone) when buttons are
pushed on the touchscreen.
Calibrate
Used to calibrate the touchscreen (see “Calibrate” in this document
for additional information).
10
Summary of Contents for 53A00-2
Page 2: ...Copyright 2009 Home Automation Inc ALL RIGHTS RESERVED ...
Page 19: ......
Page 20: ......