9
ASSEMBLY INSTRUCTIONS
Hardware Used
DD
HH
8
9
8
.
Support heater. Slide three washers washer
ĭ
8 (DD )
over threaded end of spacer. Locate reflector assembly
on 3 spacers. Install three washers
ĭ
8 on spacers and
securely tighten wing nuts (HH) but do not overtighten.
9. Connect hose and regulator to cylinder .
The propane gas and cylinder are sold separately.
Use a standard 20 lb. propane cylinder only.
Use this heater only with a propane vapor withdrawal
supply system. See chapter 5 of the standard for
storage and handling of liquefied petroleum gas,
ANS /NFPA 58. Your local library or fire department
should have this book.
A minimum supply pressure of 0.4 p.s.i. is required for
the purpose of input adjustment for propane gas. Storage
of an appliance indoors is permissible only if the cylinder
is disconnec ted and removed from the applian ce. A
cylinder must be stored outdoors in a well-ven tilated
area out of the reach of children . A disconnected cylinder
must have dust caps tightly installed and must not be
stored in a building , garage or any other enclosed area.
The minimum permissible gas supply pressure of 10
W.C. is required for purpose of input adjustment.
The minimum hourly of 17000 Btu is required input
rating for a heater for automatic operation at ratings less
than full input rating.
The pressure regulator and hose assembly supplied
with the applian ce must be used.
The installation must conform with local codes, or in the
absence of local codes,with national fuel gas code,
ANS Z223.1/NFPA54, natural gas and propane
Installation Code, CSA B149.1, or propane storage and
handling code, B149.2.
x 6
Washer
ĭ
8
Standard 20 lb. tank
x 3
Wing nut
HH
DD
9. Connect hose and regulator to cylinder. The propane gas and cylinder are
sold separately. Use a standard 20 lb. propane cylinder only. Use this heater
only with a propane vapor withdrawal supply system. See chapter 5 of the
standard for storage and handling of lique
fi
ed petroleum gas, ANSI /NFPA
58. Your local library or
fi
re department should have this book.
A minimum supply pressure of 0.4 p.s.i. is required for the purpose of input
adjustment for propane gas. Storage of an appliance indoors is permissible
only if the cylinder is disconnected and removed from the appliance. A
cylinder must be stored outdoors in a well-ventilated area out of the reach
of children. A disconnected cylinder must have dust caps tightly installed
and must not be stored in a building, garage or any other enclosed area.
The minimum permissible gas supply pressure of 10 W.C. is required for
purpose of input adjustment. The minimum hourly of 17000 Btu is required
input rating for a heater for automatic operation at ratings less than full input
rating.
The pressure regulator and hose assembly supplied with the appliance must
be used. The installation must conform with local codes, or in the absence
of local codes,with national fuel gas code, ANSI Z223.1/NFPA54, natural
gas and propane Installation Code, CSA B149.1, or propane storage and
handling code, B149.2.
