~ 14 ~
Cleaning
For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly.
Caution! The appliance may not be connected to the mains during cleaning. Danger of electrical shock!
Before cleaning switch off the appliance from the mains and remove the plug. Never clean the appliance
with a steam cleaner. Moisture could accumulate in electrical components and run the risk of electrical
shock! Hot vapours can lead to the damage of plastic parts. The appliance must be dry before it is placed
back into service.
Important! Ethereal oils and organic solvents can attack plastic parts, e.g. lemon juice or the juice form
orange peel, butyric acid, cleanser that contain acetic acid.
Clean drain hole
To avoid defrost water overflowing into the fridge, periodically clean the drain
hole at back of fridge compartment. Use a cleaner to clean the hole as shown
in diagram opposite.
Do not allow such substances to come into contact the appliance parts.
Do not use any abrasive cleaners
Remove the food from the freezer. Cover and store in a cool place.
Clean the appliance and the interior accessories with a cloth and
lukewarm water. After cleaning wipe with fresh water and rub dry.
After everything is dry place appliance back into service.
Defrosting of the freezer
The freezer compartment, however, will become progressively covered with frost. This should be removed.
Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. When the ice
becomes very thick on the inner liner, complete defrosting should be carried out as follows:
Unplug the unit from the mains socket.
remove all stored food, wrap it in several layers of newspaper and place in a cool place.
keep the door open and place a basin underneath the appliance to collect the defrost water.
when defrosting is completed, dry the interior thoroughly
plug in the power socket to run the appliance again.
Replacing the lamp
Caution! Before replacing the lamp, ensure you disconnect the appliance from the mains power supply.
Lamp specification is listed in rating label. Follow below process to replace the lamp
1. Set the temperature regulation knob at number “0” to switch off the
appliance.
2. Unplug the appliance to ensure the appliance is disconnected from
main power supply.
3. Remove the screw of the lamp cover.
4. Pull the lamp cover out.
5. Unscrew the lamp.
6. Fit new lamp as illustrated in the diagram opposite, then replace the
lamp cover and screw.
7. Plug in the appliance and regulate the knob to right position.
