Holzstar 5902423, Instruction Manual

Page: 20 / 38

20 HBS Series | Version 1.02
Seetings
Fig. 40: Set cutting speed
Step 4: Close the lower roller cover.
Adjusting the belt tension
Step 1: Release the lock of the motor and turn the motor
counterclockwise to reduce the tension of the
drive belt. Turn the motor clockwise to increase
the tension of the drive belt.
Fig. 41: Adjust belt tension
Step 2: Position the motor so that the drive belt in the
middle can be pressed through approx. 10mm.
Then fix the engine again and close the lower
roller cover.
Fig. 42: Belt tension
Changing the saw band
A saw blade change is required when using different ma
-
terials and material thicknesses, as well as worn saw
band.
Step 1: Detach the guide rail and remove it from the
band saw.
Fig. 43: Remove guide rail
Step 2: Open the upper and lower roller cover.
Fig. 44: Open the roller cover
NOTE!
If necessary, adjust the motor position to adjust the
belt tension.
Speed
Engine pulley
Bottom engine pulley
Screw for engine
Driving belt
Engine pulley
Belt pulley
DANGER!
Before changing the saw blade, switch off the ma
-
chine, pull out the mains plug and wait until the band
saw band stops.
Wearing safety gloves!
DANGER!
Use only suitable saw bands!
DANGER!
Make sure to insert the new saw blade correctly!
Make a note of which direction the teeth of the old saw
band are pointing!
Handle guide rail
roller cover