ASSEMBLY
HOLZMANN Maschinen Austria www.holzmann-maschinen.at
Seite 29
Tischkreissäge / table saw TS 250
13.2.2
Installation and adjustment of the riving knife
Remove the blade guard cover.
Loosen the screws on the riving knife with a
13
mm wrench easily.
Adjust the riving knife to a distance of about
3
mm -
8
mm for a saw blade (Fig. 6).
Drag the riving knife with the screws again.
Check that the riving knife is parallel to the saw blade by means of the testing block.
(Fig. 7)
Attach the blade guard cover on the splitting wedge.
NOTE
:
This procedure
should
be repeated
each time
the
when the saw blade
is replaced.
13.2.3
Electrical connection
Only a qualified electrician is authorized for the electrical connection, including the installation of
the supply part. This must be cut off before the electrical connection. Only when the main power
supply is cut off, each contact can be closed. The cowl box is attached to the back of the machine
body. There is also a junction box on the side, which you have to connect only to the marking.
13.3
Earthing connection
A T T E N T I O N
When working on an ungrounded machine:
Serious injury due to electric shock in the event of a malfunction possible!
Therefore:
Machine must be grounded and be connected to a grounded outlet
The electrical connection of the machine is ready for operation on a grounded electrical outlet!
The plug must be connected only to a properly fitted and grounded electrical outlet!
The supplied plug must not be changed. If the plug does not fit or is defective, only a qualified
electrical engineer may modify or replace these plugs!
The grounding conductor is green-yellow!
Fig. 6
Fig. 7
Riving knife
3 – 8mm
testing block
Summary of Contents for TS 250
Page 47: ......