OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
33
OBF1200
Increase speed:
Moving speed controller (
11
) in the plus direction.
Decrase speed:
Moving speed controller (
11
) in the minus direction.
Adjusting the routing depth (Fig. 17/ Pos. 11)
Put machine on workpiece.
Setting the mounting screw (
16
) using the scale to the desired routing depth and fix it with
the fixing screw.
Test set routing depth on a test workpiece.
Routing
To avoid damage to the router, make sure there are no foreign objects attached to the workpiece.
Connect the machine with the power cord to the power supply.
Hold the tool using both of its handles (
7
).
Place the router on the workpiece.
Adjust the cutting depth according to point 10.2.3.
Select the speed as described in point 10.2.2, and turn on the machine (see point 10.2.1)
Test the machine settings using on the basis of a test piece.
Do not leave the device reach full speed. Lower until the cutter to its working height and
lock the device with the locking grip (
9
).
Cutting direction:
The cutting tools rotates clockwise. That routing must always be against the rotation to avoid
accidents (Fig.
18
)
Feed speed
It is very important to machine the workpiece with the correct feed speed.
We recommend that you perform test routing with the same type of workpiece -material- before
routing the actual workpiece. In this way, the most suitable feed speeds let's find the best.
Feed speed to low:
The cutter could heat up too much. If combustible material such as wood processing, the
workpiece could ignite.
Feed speed to high:
The cutter may be damaged. The cutting result is rough and uneven.
Let the router to drain completely before removing the workpiece or putting down the
router before you take the plunge router.
