OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
34
OBF1200
Routing in stages
Depending on the hardness of the material and cutting depth to be machined is to proceed in
several stages.
Adjust the stops according to point 10.1.6
Should be routing in several stages, so turning the end stop revolver (
14
) after adjusting
the cutting depth according to point 10.2.3 so that there is the depth stop (
19
) above the
highest end stop (
15
).
Now route in this setting. Adjust so after completion of the first routing operation adjust the
end stop revolver (
14
), so that the depth stop (
19
) is over the end stop (
15
). Perform well
in this setting by a routing operation.
Set Now lowest end stop (
15
) and lead to the end milling.
Routing circles with the compass point (13)
For cutting circles around a center point, proceed as follows:
Fit the compass point (13) assembly and adjustment in accordance with section 10.1.3.
Compass point (13) put on the center of the circle to be routing and press
Complete the routing operation as described in point 10.2.4
Routing with the parallel stop (21)
For routing along a straight workpiece outer edges proceed as follows:
Fit the parallel stop (
21
) as described in point 10.1.2
Guide
the parallel stop (
21
) on the outer edge of the workpiece along.
complete the routing operation as described in point 10.2.4
Free-hand routing
The router can also be operated without guide rods. In freehand routing for creative work such as
production of logos.
For this, use only a very flat routing adjustment!
When editing of the workpiece, the direction of rotation of the cutter (Fig.
18
)
Shape and edge cutting (Fig. 19)
Special cutters with a guide ring may be used for cutting shapes (
a
) and edges (
b
).
Fit the cutter
Carefully guide the machine on to the workpiece.
Guide the guide journal or ball bearing (
c
) along the workpiece with gentle pressure.
Depending on the material, proceed with larger cutting depths in several stages.
Keep all milling the router in two hands.
ATTENTION
After working with the router, the milling tool for a relatively long time is very hot!
