HOLZMANN MASCHINEN HBS245HQ, User Manual

Page: 43 / 54

HOLZMANN MASCHINEN www.holzmann-maschinen.at Strana 43
PÁSOVÁ PILA / WOOD BANDSAW HBS245HQ
16 TROUBLE SHOOTING
Disconnect the machine from the power supply prior to any checks performed at the
ma-chine itself!
Trouble Possible cause Solution
Saw stops or will not start

Overload tripped

Saw unplugged

Fuse blown or circuit breaker
tripped

Cord damaged

Allow motor to cool and reset
by pushing off switch

Check all power connections

Change fuse or reset circuit
breake

Change cable
Does not make accurate 45°
or 90° cuts

Stop not adjusted correctly

Angle pointer not set
accurately

Miter gauge out of adjustment

Check band with square and
adjust stop

Check band with square and
adjust pointer

Adjust miter gauge
Band wanders during cut

Fence not aligned with band

Warped wood

Excessive feed rate

Incorrect band for cut

Check and adjust fence

Select another piece of wood

Reduce feed rate

Change band to correct type
Saw makes unsatisfactory
cuts

Dull band

Band mounted wrong

Gum or pitch on band

Incorrect band for cut

Gum or pitch on table

Replace band

Teeth should point down

Remove band and clean

Change band to correct type

Clean table
Band does not come up to
speed

Extension cord too light or too

Low shop voltage

Replace with adequate size
cord

Contact your local electric
company
Saw vibrate excessively

Base on uneven floor

Bad v-belt

Bent pulley

Improper motor mounting

Loose hardware

Reposition on flat level surface

Replace v-belt

Replace pulley

Check and adjust motor

Tighten hardware
Saw band runs in opposite
direction

2 of the 3 leading phases are
switched whether in Plug or
socket

Shut off machine immediately.
Let the connection to supply
circuit be corrected by an
electrician!
MANY MALFUNCTIONS AND DEFECTS CAN BE AVOIDED BY LETTING THE MACHINE BE
CONNECTED TO YOUR POWER SUPPLY BY A CERTIFIED ELECTRICIAN