HOLZMANN MASCHINEN HBS245HQ, User Manual

Page: 37 / 54

HOLZMANN MASCHINEN www.holzmann-maschinen.at Strana 37
PÁSOVÁ PILA / WOOD BANDSAW HBS245HQ
N O T I C E
After setting and before switch on turn the upper wheel roll by hand a few
times to see if the band saw runs out of the rollers. If this is the case, the
blade must be aligned again.
14.2.3 Blade tension
W A R N I N G
Check the blade tension before any operation
N O T I C E
Too much tension: The band saw blade can break
Too less tension: The band saw blade can slip and stop
 Raise upper blade guide fully.
 Taking the blade width into consideration, turn the knob to adjust tension (Fig.j; 1j).
 Check tension by pushing with a finger, halfway between table and upper
 Turning the setting knob clockwise increase the blade tension
 Tuning the setting knob counter-clockwise reduce the blade tension
After the end of the work dissipate the band saw blade a little bit.
14.2.4 Blade guide
The blade guide is used to adjust the distance from the band saw blade to the guide bearing.
W A R N I N G
Do not adjust the sawband guidance when the machine
is working!
Heavy injuries on hands and arms are possible!
Sawband guidance can be adjusted only after the
sawband direction and the sawband tension has been
proofed.
Before you adjust the sawband guidance switch off the
machine and wait until the sawband is standing completely
still.