CHYBA! POMOCÍ KARTY DOMŮ POUŽIJTE U TEXTU, KTERÝ SE MÁ ZDE ZOBRAZIT, STYL
ÜBERSCHRIFT 1.
HOLZMANN Maschinen Austria
www.holzmann-maschinen.at
Seite 38
Metalldrehbank/Metal turning lathe ED1000F
MAINTENANCES AND SERVICING
1.33
Lathe alignment
When the lathe is installed and ready for use,
it is recommended to check the machine
alignment before commencing work. Align-
ment and leveling should be checked regularly
to insure continued accuracy. Adopt this pro-
cedure as follow: take a steel bar with a diam-
eter of appr. 50mm and length of appr.
200mm. span it in the chuck without using the
center. Then cut off a chip over a length of
150mm and measure the difference in A and
B. In order to correct a possible difference,
loosen the screw (J) clamping the headstock
on the bed. Adjust the headstock with set-
screw (s). Repeat the above procedure until all
measuring is correct. The lathe will be cutting
correctly.
1.34
Saddle strip
Wear on the rear saddle gig strip may be accommodated
by adjustment of the socket head set screws.
The procedure for adjustment is to first take off the rear
splash guard (when fitted), release the hexagon nuts and
turn the socket head set screws slightly in clockwise and
the re-clomp the hexagon nuts. Care should be taken to
avoid over adjustment, α45°turn at the socket head set
screw approximately 0.125(0.005”) take up in the gibe.
1.35
Cross slide
Wear on the taper-gibe strip may be adjusted for
by clockwise rotation of the slotted head screw on
the front face of the cross slide. The procedure is
to first slacken the similar screw at the rear then
retighten this after adjustment to clamp the gibe
in its new position.
Summary of Contents for ED1000F
Page 92: ......
