CHYBA! POMOCÍ KARTY DOMŮ POUŽIJTE U TEXTU, KTERÝ SE MÁ ZDE ZOBRAZIT, STYL
ÜBERSCHRIFT 1.
HOLZMANN Maschinen Austria
www.holzmann-maschinen.at
Seite 37
Metalldrehbank/Metal turning lathe ED1000F
1.32
CHUCKS AND CHUCK MOUNTING
When fitting chucks or faceplates, first ensure that spindle and chuck tapers are be necessary
when mounting a new chuck to re-set the cam lock studs (A). to do this, remove the cap-head
locking screws (B) and set each stud so that the scribed ring (C) is flush with the rear face of the
chuck-with the slot lining up with the locking screw hole.
Now mount the chuck or faceplate on the spindle nose and tighten the six cams in turn. When
fully tightened, the cam lock line on each cam should be between the two V marks on the spindle
nose. If any of the cams do not tighten fully within these limit marks, remove the chuck or face-
plate and re-adjust the stud as indicated in the illustration. Fit and tighten the locking screw (B)
at each stud before remounting the chuck for work. A reference mark should be made on each
correctly fitted chuck or faceplate to coincide with the reference mark scribed in the spindle nose.
This will assist subsequent remounting. Do not interchange chucks or faceplate between lathes
without checking for correct cam locking.
Summary of Contents for ED1000F
Page 92: ......
