OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
21
BS125M
12.4.3
Setting the cutting angle
The vice (6) is used to
hold the workpiece
securely during operation
of the metal band saw.
The metal band saw can
be adjusted at an angle of
0° to 60°. To adjust:
Loosen the locking handle
(7). Position the mitre
plate (8) at the desired
angle using the angle
scale. Then retighten the
locking handle.
N°
Description
6
Vise
7
Locking Handle
8
Miter Plate
12.4.4
Electrical connection
The electrical connection of the machine is prepared for operation at an earthed socket.
The device may only be operated on safety sockets that are properly installed and earthed
in accordance with local regulations and ordinances.
Make sure that the mains voltage meets the requirements of the machine.
The connector plug must not be manipulated!
The earthing conductor is yellow-green!
The power supply must be fused with 16A.
Make sure that any extension cable is in good condition and suitable for power
transmission. An undersized cable reduces the power transmission and heats up
considerably.
Do not abuse the cable. Never use the cable to carry, pull or disconnect the power tool.
Keep the cable away from heat, oil, sharp edges or moving parts. Damaged or entangled
cables increase the risk of electric shock.
A damaged cable must be replaced immediately!
13
OPERATION
W A R N I N G
Electrical Voltage! Conversion and adjustment work on the unit, which is not
disconnected from the power supply, may result in serious injury or death. Always
disconnect the device from the power supply and secure it against unintentional
restarting before changing over or adjusting work.
13.1
Operating instructions
N O T I C E
Readjusting or adjusting the workpiece only when the band saw blade stand still
and the saw arm is completely folded up.
Always run the engine at full speed before starting to saw.
If you no longer use the machine on the same day, loosen the band saw band a
little.
6
7
8
