HOLZMANN MASCHINEN BBS 350, User Manual

Page: 22 / 41

TRANSPORT
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at Seite 22
BBS 350
N O T I C E
A safety note designed in this way indicates a potentially dangerous situation which,
if not avoided, may result in property damage.
Irrespective of all safety regulations, your common sense and your corresponding technical
suitability/training are and will remain the most important safety factor for error-free operation of
the machine. Safe working depends first and foremost on you!
14 TRANSPORT
W A R N I N G
Damaged or not sufficiently viable hoists and lifting devices can cause serious injury
or even death. Always check hoists and load lifting devices for adequate load-bearing
capacity and perfect condition, carefully fasten the loads and never keep them under
suspended loads.
Attach the hoists to the designated components and pay attention to a balanced weight
distribution.
15 ASSEMBLY
15.1 Check scope of delivery
After delivery, check the machine immediately for transport damage and missing Parts.
15.1 Preparatory activities
15.1.1 Workplace requirements
For optimizing the function of machine and to achieve maximum cutting precision, it is
recommended to install the machine on a flat concrete area, in a hall or under a shelter. The
use of any other base must be consulted with the producer.
The machine must be installed in a hall or under a shelter. The machine must be protected
against rain.
Recommendation/preconditions:
a) Plan sufficient space for feeding in the work piece, removing the work piece and for
maintenance of the machine.
b) The working area for the saw and them operator must be flat, clean and must not threaten
the operation and activity of the operator.
c) Installation of the lifting equipment for heavy work pieces.
d) Ensure good lighting in the workplace.
For the spatial arrangement of machines keep to all valid standards and hygiene regulations
about the air space in the workplace.
The location of the machines must exclude any threat to the other employees from the
operation in the case of an accident with the tool, ejection of the tooled materials in the case
of insufficient clamping, cutting of the saw band, etc.