[Type here]
[Type here]
P a g e
|
19
KOPIS 1
Adjust Channel Endpoints
If your channel endpoints are not adjusted correctly, the quadcopter may rotate faster in one direction
than the other. In extreme cases, you may not even be able to arm! To check whether your channel
endpoints are adjusted correctly, first REMOVE THE PROPS from your KOPIS. DO NOT SKIP THIS STEP.
Plug in a LiPo to the KOPIS and plug the KOPIS into your computer’s USB port.
Go to the Betaflight Configurator Receiver Tab. Lower your throttle all the way down. The Throttle
channel should have a value of 1000. Raise your throttle all the way up. The throttle channel should
have a value of 2000. Push your yaw stick all the way to the left. The Yaw channel should have a value of
1000. Push your yaw stick all the way to the right. The Yaw channel should have a value of 2000. The
same should be true for Pitch and Roll: down or left should be equal to 1000; up or right should be equal
to 2000.
If your channels are not equal to 1000 and 2000 when you fully deflect the sticks, you need to adjust
your channel endpoints.
Adjusting Channel Endpoints on a FlySky Radio
Here are instructions for adjusting channel endpoints on a FlySky FS-i6 radio.
1.
Power on the radio.
2.
The Hold down the “OK” button to enter the System Setup screen.
3.
Press the Down button to highlight the Functions Setup option.
4.
Press Ok to enter the FUNCTIONS menu.
5.
Press the Down key to move the selection arrow to “End Points”. Press Ok.
