[Type here]
[Type here]
P a g e
|
8
KOPIS 1
Bind the Receiver
Now that your receiver is installed in your KOPIS, the next thing you need to do is
bind
the receiver to
your Taranis. Binding is the process of letting the Taranis and the XSR know that they should talk to each
other. It’s how your quadcopter knows to listen to your transmitter and not anybody else’
s.
The exact instructions for binding your receiver will be different depending on what receiver and
transmitter you have. Here are instructions for some common receivers.
Binding A FlySky Receiver
For the FlySky A8S receiver, the binding instructions are as follows.
1.
Un-plug the A8S receiver from the wire header that came pre-installed on your KOPIS.
2.
REMOVE THE PROPS from your KOPIS for safety. DO NOT SKIP THIS STEP.
3.
Plug in your LiPo to the KOPIS main battery lead.
4.
Hold down the BIND button on the back of the A8S receiver. While holding down the BIND
button, plug the A8S receiver in to the wire header that came pre-installed on your KOPIS. The
LED on the receiver will blink quickly.
5.
With the FS-i6 transmitter powered off, hold down the Bind Key, then power on the radio while
continuing to hold down the Bind Key. The Bind Key is on the front of the radio, to the lower-left
of the screen. The radio will power on and the screen will say “RXBinding.”
6.
The LED on the receiver will switch from quickly blinking to slowly blinking. This indicates that
binding has occurred.
7.
Power down the FS-i6 transmitter.
8.
Power the FS-i6 transmitter back up, this time without holding down the BIND KEY. The LED on
the receiver will go solid red (no blinking). This indicates that the receiver is communicating with
the transmitter.
