EN
GCU 50* (i) EVO 3
916.001.652_002
43
7.3
The green LED of the tool does not light up when the tool is switched on
/i
7.4
The useful operating time between the individual charging cycles of the
battery pack is less than 5 minutes
/i
7.5
The deadman's handle is jammed or doesn't return automatically to the
neutral position
/i
7.6
The light is weak or gives no light at all
/i
7.7
The cutting is poor
/i
The led of the on/off switch flashes quickly. The electric motor is too hot. Wait for the temperature of
the tool to decrease.
Possible cause
Solution
The battery pack is not locked.
Remove the battery pack and slide it in the tool again
until the battery pack lock snaps tight.
The battery pack is in the sleep mode. This
happens when tool is not used for about 10
minutes.
To activate the battery pack again:
•
Press the SOC indicator button, or
•
Operate the on/off switch again, or
•
Reinstall the battery pack.
Possible cause
Solution
The battery pack is defective.
Replace the battery pack.
Possible cause
Solution
The deadman's handle is damaged
externally.
Have it repaired by a Holmatro Certified Technician.
The deadman's handle is faulty.
Have it repaired by a Holmatro Certified Technician.
Possible cause
Solution
The battery is (almost) empty.
Replace the battery.
Possible cause
Solution
The blades are damaged.
Sharpen or file the cutting edge of the blades in the
correct shape.
The tightening torque of the centre bolt is
incorrect.
Tighten the bolt to 50 Nm.
Possible cause
Solution
