6
CAUTION
CERTAIN SURFACES ARE EXTREMELY HOT DURING OPERATION AND CARE
SHOULD BE TAKEN WHILE USING THIS UNIT.
START UP
When the toaster has been plugged into a suitable outlet and power supply, the word
OFF
will be displayed on the L.E.D. read out.
A.
Press the
ON/OFF
button once to turn on the toaster. The toaster will now enter into
pre-heat and
PREHT
will be displayed (the elements will begin to glow but the conveyor and
fan motor will not turn on).
B. After one minute,
the fan motor will turn on and the conveyor will begin turning at the
previously saved setting (for initial start up, the drive motor will operate at the factory default
setting).
C.
After four minutes,
the display will show the last used program selection i.e.
TOAST,
BAGEL, MUFFIN
or
OTHER
(for initial startup,
TOAST
will be the last program selected).
DAILY OPERATION
Check the power cord to insure that it is plugged into a proper outlet.
Press the ON/OFF button once to turn the toaster on.
Press the button a second time to turn the toaster off.
NOTE:
When the toaster is turned off, the fan and conveyor motors will continue to run for
fi
ve minutes. The words
COOL
and
DOWN
will be alternately displayed during that time.
After
fi
ve minutes, the word
OFF
will be displayed until the
ON/OFF
button is pressed again.
For units equipped with a
POWER SAVER
feature, the three operating modes are:
ON
Unit has entered the pre-programmed level of power savings.
OFF
Power Saver feature is turned off.
AUTO
If the toaster has been idle for a pre-set period of time, the unit enters Power Saver
mode until one of the menu buttons has been pressed.
Once the toaster has been pre-heated, the menu buttons can be pressed to change to
TOAST, BAGEL, MUFFIN,
or
OTHER.
OPERATING HINTS AND SAFETY
Disconnect power to the unit with the
ON/OFF
button at the end of each day of operation.
Do not leave the unit in operation without an attendant.
Turn the
POWER SAVER
Switc h to Standby during idle periods. It will take only a few
minutes to regain operating temperature.
Do not leave the unit at high temperature when not in use or during idle periods. This will
cause food particles and grease
fi
lm to carbonize.
TOASTER COMPONENTS
LOAD UP
CRUMB TRAY
CONTROLS
LCD DISPLAY
FRONT
AIR INTAKE FAN
HIGH LIMIT RESET
POWER CORD
Summary of Contents for QCSe-2 SERIES
Page 19: ......
