4
INSPECTION & ASSEMBLY
UNCRATING AND INSPECTING
Unpack the unit and components from the shipping container. Remove all visible packing
material and those from inside the cooking chamber. If damage is discovered,
fi
le a claim
immediately with the carrier that handled the shipment. Do not operate the unit if it was
damaged during shipping.
ASSEMBLY AND INSTALLATION
The unit was shipped fully assembled and ready to plug into a 6-30R receptacle. If
improper electrical supply is determined, contact a quali
fi
ed electrician prior to using the
unit. Removal and replacement of the power cord and plug will void the warranty. For
assistance, contact your local authorized service agent for service or required maintenance.
Refer to the Authorized Service Agent Listing that was supplied with unit, or go to the inside
cover to
fi
nd out how to obtain one.
Level unit using the adjustable feet under the unit (approximately 1/2" adjustment).
Before using the unit for the
fi
rst time, wipe down the exterior with a damp cloth.
The toast chute may be installed for either front or rear product discharge as shown below.
FRONT DISCHARGE
REAR DISCHARGE
TOAST CHUTE
MOUNTING STUDS
ADJUSTABLE HEAT SHUTTER
The DT14 is equipped with an adjustable
front heat shutter. This is designed to
maintain a temperature, by preventing the
heat from escaping. This shutter may be
adjusted from an opening clearance of 1
1/2" up to 3". To adjust shutter, loosen
the single Phillips screw on the front of
the top cover, slide the shutter up or down
to desired height and tighten the Phillips
screw.
HEAT
SHUTTER
