35
V125T/July 2020/V1.1
Insert the cutter and pin into the machine arbor, ensure both of the cutter shank flats align with the
fixing screws on the machine arbor.
Once the cutter is aligned and pressed fully home tighten the two Allen screws with the key supplied.
ALWAYS MAKE SURE THE POWER PLUG IS DISCONNECTED!
[image 18] Standard Arbor - Guard not shown for clarity.
TAKE CARE WHEN HANDLING SHARP CUTTERS
2.
Precisely mark the centre position of the of the hole on the workpiece.
3.
Use the pilot pin to position the machine and in the correct position, with the tip of the pilot
pin to meet the marked center of the hole.
4.
Fix the machine by switching on the magnet and verify that the drill is in the right position
and that the machine is fully secure on the work piece.
5.
Open the valve/tap of the coolant system (if fitted) to allow the coolant oil to flow.
6.
Switch on the motor and allow it to run up to the set speed.
