HOLDEN MP SPARK, Owner'S Manual

Page: 178 / 210

Holden Spark (Next Gen) Owner Manual (GMK-Localising-Holden-9507018) -
2016 - crc - 11/19/15
176 Vehicle Care
18.4. Drain excess tyre
pressure with the button
near the pressure
indicator.
{
Warning
If the recommended pressure
cannot be reached after
approximately 10 minutes, the
vehicle should not be driven. The
tyre is too severely damaged and
the tyre sealant and air
compressor kit cannot inflate the
tyre. Disconnect and stow the tyre
sealant and air compressor kit
back in its original position.
Contact a Holden Dealer.
19. Detach the tyre repair kit.
20. Push the catch on the bracket
to remove the sealant bottle
from the bracket.
21. Unscrew the tyre inflation hose
from the sealant bottle. This
prevents sealant from
escaping.
22. Stow the tyre sealant and air
compressor kit in the load
compartment.
{
Warning
Always stow the tyre sealant and
air compressor kit in its original
position. Unsecured loads
increase the risk of injury during
heavy braking, sudden avoidance
manoeuvres or a collision.
23. Remove any excess sealant
using a cloth.
24. After inflating the tyre, remove
the maximum speed label and
place it in a visible location.
It reminds you to drive
cautiously and not to exceed
80 km/h until the damaged tyre
is replaced or repaired.
25. Continue driving immediately
so that sealant is evenly
distributed within the tyre.
26. After driving approximately
10 km (but no more than
10 minutes), stop at a safe
location to check the tyre
pressure.
27. Screw the compressor air hose
directly onto the tyre valve and
compressor to check the tyre
pressure.
28. If the tyre pressure is more
than 19 psi / 130 kPa, set it to
the correct value (approx.
33 psi / 230 kPa).
29. Repeat the procedure from
Step 25 until there is no more
loss of pressure.