FM-ONE
HOKUTO DENSHI
CO;LTD;
株式会社
14
A2: Program
To start writing from FM
－
ONE Project
File Maker, click on the Program key with
File/Parameter in a selection mode.
To program, be sure to connect the main
body, the USB cable and the target board as
in the diagram on the right diagram.
There are actually two operational procedures as follows:
Select the file and parameter as shown in the previous page, and click on
Program.
A new project, which is not saved yet, is automatically saved under the name of
“
Default
”
and writing is started.
Load the project file saved following the direction in the previous page,
and then click
on
Program.
An existing project file, which has been saved before, is automatically saved (overwritten) in the CD under its original
name and then writing is started.
Likewise in the previous page, start FM
－
ONE Project File Maker.
When a new project is set up, or when the existing program is
loaded to resume writing in it, configure your computer in DETAILS
mode and click
Program
.
A new project is saved under the name of
default
and writing
is started, while an existing project is
SAVED
under the
original name and likewise writing is started.
When the existing project is loaded and written in without
modifying, load the project leaving the screen below as it
is and click on
Program.
Saving
is executed and writing will immediately start.
Writing started, to an offline mode
A
utomatically reset to ONLINE
MOT/HEX
P
P
C
C
ProjectFileMaker
USB
cable
From
PC to CF
Target board
Flash
on-chip microcomputer
FM-ONE
Online operation
From
CF to on-chip
FlashROM
When
Program
isbeing executed,
“Program”
is displayed here.
※
Program key
is
valid only when MCU
is selected and
FM
－
ONE is
connected.
Error occurrence
An error message is displayed on the PC screen.
Errors are produced in the project file as log.txt.
Completion of writing
When writing is properly completed, a message
to the effect is displayed on the PC window.
Log.txt indicating successful completion is
produced in the
project file.