WS-BAG INSTALLATION
WS-BAG INSTALLATION
WS-BAG INSTALLATION
3
Make a “U” as shown in Fig 1.3. This allows your USB to go around the top lip of
your fairing when installing the bag. On the far right of the bag is a 2nd “X”
grommet that allows Hogtunes audio cable to pass out of the bag to the “aux in”
on the radio. With USB power, and the audio out to the aux in, the zipper pouch
is the ideal place to have your audio device for long rides!
Step#1: Locate the 3 screws highlighted by
white arrows in the image below.
These are the screws that “clamp”
the windshield between the bikes
inner and outer fairing. In most
cases, the 3 screws will only need to
be loosened before moving to Step
#2, but may need to be removed
depending on the bike.
Step#2: Slide the lower, backing portion of the windshield bag down between
the inner dash and the windshield.
NOTE: If using the USB cable option,
you may need to loosen all 7 fairing screws to allow the outer fairing to
pull back far enough to get the “U” around the top lip of the inner fairing
as shown in Fig 1.3. Once the bag is in place, take any slack out of the
loop.
Step#3: Align the center hole in the outer fairing, and windshield molding
(if present) with the center “slot” in the windshield bag and the center
threaded insert of the inner fairing.
Step#4: Loosely re-install the 3 screws. Check the fit and alignment of the
windshield and the bag before tightening the screws securely.
Step#5: Make sure that none of the parts of the bag will touch or interfere
with anything that can impair the operation of the bike! It is your
responsibility to make sure the installation of the bag does not create an
unsafe, or illegal
situation.
NOTE
: After 50 miles of
riding (80km), recheck the
mounting of the bag to
make sure it is still securely
mounted to the fairing.
Summary of Contents for WS-BAG
Page 1: ......
