6
This manual assumes you have already removed the woofer, tweeter and grill, had
the lids painted, and you are now installing the new lids on your bike.
Remove the saddlebag from the bike, and put on a stable working surface. For
obvious reasons, blankets etc. on your work surface will help protect the paint.
Step #1: The white circle in Fig 1.1 above is where a 3/4” (19mm) hole will
be drilled. This hole is where the supplied Hogtunes rubber grommet
will go to allow the lids speaker wire to pass from the saddlebag.
We
strongly suggest putting masking tape over the painted
area to be drilled. We also suggest starting with a small
bit, and gradually working your way up to the 3/4”
(19mm) hole.
Drilling the hole with the lid still on is recommended!
Step #2:
The supplied grommet in Fig 1.2 is “split” to make the install much
easier once the wire is in the bag. The white circle in the picture shows
a “plug” that can easily be removed. If the only wire you have going
into your saddlebag is the speaker wire, leave the plug in place. If
you have a second wire for such things as lighting etc., removing the
plug from the grommet will allow the second wire to also pass without
having to drill additional holes in your saddlebag.
Do Not Use “Thread Lock” or “Screw Glue” of
Any Kind As It Destroys Plastic And Will Cause
Part Failure NOT Covered By Warranty!
Figure 1.1
Figure 1.2
Section 2
SPEAKER LID INSTALLATION
SPEAKER LID INSTALLATION
SPEAKER LID INSTALLATION