13
Step #4: “Stick” one of the amplifiers to the BACK of the plate in the same
orientation as shown in Fig 1.3.
Step #5: Using Fig 1.1 on page 9 for reference, locate the 4 bolts on each
of the 4 corners around “B” and remove the ones on top left and top
right (only). It’s best to have the amp on the plate near you before
proceeding.
Step #6: Using Fig 1.1 on page 9 for reference, locate “C” and “D” which are
the 2 pin plugs on each front speaker’s cabinet that have pink and pink
with black stripe. These plugs attach the speaker’s wiring to the bike’s
wiring and need to be separated. Locate the “main input” harness and
insert its 8 pin plug into the “audio input” on the PRIMARY (back side)
amplifier. On this harness, take the plug with the green heat shrink on
the end and install it into the mating plug on the brake side of the bike.
Take the plug with the yellow heat shrink on the end and install it into the
mating plug on the clutch side of the bike.
Step #7: Locate a bag with a harness in it that says “Audio Out” and plug it
into the amplified out “pigtail” on the PRIMARY (back) amplifier. Take the
2 pin plug with the blue heat shrink on one end and install it into the
plug going into the brake side speaker cabinet. Take the 2 pin plug
with the brown heat shrink and install it into the plug going into the
clutch side speaker cabinet.
Take one of the 2 power connectors on the splitter harness, and plug it
into the power connector on the PRIMARY (back) amplifier.
IMPORTANT—Before you proceed, make sure you
understand the Radio Flash Selector info on the next
page. The PRIMARY (back side) Amp will be difficult
to adjust later if you don’t do this now!
IMPORTANT
In this install we refer to one amp as the “Primary” and the
other as the “Secondary.” The Primary always has the main
input harness go into it, and is always the amp that powers the
front fairing speakers. When installed, the amp on the
BACK SIDE of the plate is the PRIMARY AMPLIFIER.