GETTING STARTED
GETTING STARTED
3
We strongly suggest following the order of this manual. Wire harnesses need to be
run from the front of the bike to the back, and from the back to the front. Following
the manual as its written will help keep installation time to a minimum.
The supplied WBA 400.2R’s are powerful amplifiers made to work with 4
Ω
(ohm)
speakers only (same as supplied in this kit).
The amplifier’s have built in protection and will turn itself off if your charging
system/battery goes below 10.5 volts.
In very high heat situations the WBA 400.2R’s will shut themselves off before they
damage themselves. Once cooled down to safe operating temperatures, it will turn
itself back on.
The WBA 400.2R’s are a Class D design. It should be understood that
ALL Class D amplifiers, REGARDLESS OF BRAND, cause a reduction in
FM reception. The WBA 400.2R’s feature a proprietary circuit design
called R.E.M.I.T. (Reduced Electro Magnetic Interference Technology)
that Wild Boar Audio believes gives the BEST FM reception
available for any Class D Amplifier designed for a motorcycle.
If you add additional amplifiers to your system, reduction
of FM reception is increased and is considered normal.
Wild Boar Audio understands that some riders prefer the cosmetics of
in fairing antennas, however it should be noted that NOTHING
works as well as the factory antenna. If FM is an important part of
your riding experience, we strongly advise against the use of
any in fairing type antenna!
BEFORE
BEFORE
GETTING STARTED
GETTING STARTED
Remove the bike’s seat, and undo the main (+ and -) connectors from the battery.
Remove the outer fairing/headlamp assembly and set aside. Refer to a service
manual if you need help with this. NOTE: Placing a towel on the front fender can
help prevent scratches or “dings” from dropped tools or fasteners, etc.
GETTING STARTED
BEFORE
GETTING STARTED