6
3 Delivery and preparing for use
Your
SWINGBO Plus
wheelchair will normally be supplied
completely mounted with detached or folded push-bar / push-handle
and with removed front castors and rear wheels. (1).
The original package contains the following parts:
• Wheel chair with detached or folded push-bar / push-handle
• Rear wheels and quick-release axles unmounted
• Front castors already mounted in the front castor forks
• Additional accessories as ordered
• Instructions and list of tools required
Please remove the transport packaging carefully.
To prepare the wheelchair for use please proceed as follows:
• Grip the head of the quick-release axle as illustrated (2) and press
the release knob.
• Whilst pressing the release knob, position the quick-release axle
into the rear wheel bearing (3).
• Place the wheelchair onto the front castors and lift the wheelchair
by holding the rear of the seat (4).
• nsert the rear wheel and the quick-release axle into the axle
housing. Hold the spokes (4) close to the wheel hub and press the
release knob with your thumb. The rear wheel can then be easily
slid into position.
• Ensure that the quick-release axle is securely fixed in the axle
housing.
CAUTION!
Push each rear wheel to check that each quick-release
axle is safely located.
If your
SWINGBO Plus
is supplied with a foldable backrest it is
possible that it is folded for the transport.
• Pull the backrest at the cross tube into the upstanding position (5).
Whenever you change any settings on the wheelchair,
make sure that you firmly tighten any screws that have
been loosened.
1
2
3
4
5
