Hoggi SUPRA 2.0, Service Instructions Manual

Page: 21 / 41

21
6.5 Backrest angle adjustment
Back rigid
The rigid back offers an adjustment range of 70° to 115°.
By placing the screw from the outside in one of the front two holes in the
bearing plate, the desired range can be preset.
Each hole offers an adjustment range of approx. 22.5°.
Middle hole:
Front hole:
Back folded down and fixed.
Via the 5 hole positions of the back base and the spacer, fine
adjustment can be made within the 22.5° adjustment range, depending
on how the screw is inserted.
The further forward the screw connection, the smaller the back angle.
The backrest frame is always measured in relation to the seat frame.
The 90° backrest angle results from the centre-to-centre position.
Back with relief position and foldable
The back angle can be varied between two positions, the driving
position and the the driving position and the relief position (15°
difference).
In addition, the back can be folded down and fixed for transport. for
transport.
It is released by means of a locking bolt on the back.
Unlike the rigid back, the screw connection is made from the inside.
The adjustment range is also 70° to 115°, depending on the hole position
in which the screw is inserted.
In addition, a further 15° is achieved with the relief position, i.e. a total of
70° to 130°.
approx. 70°- 92,5°
approx. 92,5°- 115°