Operating and Maintenance Manual
12
©
HOFFMANN PP2-NCF
• Version 7.267 • 12-2017
6
Operator Environment
The work areas for the operator have been designed with
ergonomic principles in mind.
The machine owner is responsible for ease of access,
adequate lighting, fresh air supply, etc.
Specific work areas for this machine are:
In front of the machine to load and unload work
pieces and to adjust settings.
In front of the operator panel to start the
machine and to initiate the machining cycle.
At the back of the machine for maintenance
procedures only.
Rules for safe work areas:
The work area must be free from clutter and must be
kept neat and unobstructed. Local and national
safety rules, including but not limited to all
applicable OSHA Rules must be adhered to.
Access space of no less than 24” shall be available
on all sides of the machine for set-up and
maintenance procedures.
All electrical and compressed air supply lines must
be securely fastened in accordance with all local
and national safety codes. Secure all wires, hoses
and lines and do not allow lines to lie on the floor as
they may present a trip hazard to the operator.
Supply lines, wires and hoses must be inspected
periodically and replaced if any damage is
observed.
The environmental conditions must meet the guide
lines given under section 5 “Technical Date and
Specifications”.
