35
Instruction Manual
MORSØ Notch Cutting Machine
Model NFX
Adjustment of Springs (16)
The springs (16) which retain the knife block (5) in the top position are fastened in the bottom
holes in the sides of the frame by the spring holders (26).
If the up and down movement is not quick enough or if the springs loose some of their
tension after a while the spring holders (26) can be moved up to the next hole in the frame.
1. A piece of wood is placed under the knives on the table (7) in order to keep the knife
block (5) up. (H-5-1)
2. Loosen nut (a)
Only on the side you are adjusting.
3. Pull off the outer washer (b).
4. By means of a suitable tool the spring (16) is lifted so much upwards that the spring
holder (26) can be moved to the next hole.
5. Put back washer (b) and nut (a) and fasten.
6. Use the same procedure on the other side.
Service
H-5
Summary of Contents for MORSO NFXL
Page 27: ...26 Instruction Manual MORS Notch Cutting Machine Model NFX Lubrication H 1 1 H 1 2 Service H 1...
Page 31: ...30 Instruction Manual MORS Notch Cutting Machine Model NFX Grinding of knives H 3 Service H 3...
Page 33: ...32 Instruction Manual MORS Notch Cutting Machine Model NFX Draw Bar H 4 Service H 4...
Page 35: ...34 Instruction Manual MORS Notch Cutting Machine Model NFX Springs H 5 1 H 5 2 Service H 5...
