Hoffmann BH 556 Lipping Planer
- 2 -
Hoffmann Machine Company, Inc. 1386 Drexel Road Valdese, NC 28690
Phone: (828) 430 - 4510 Fax: (828) 430 - 4620 e-mail: [email protected]
www.Hoffmann-USA.com
4. Safety Rules
Read and understand these safety rules before operating this machine!
1.
Always disconnect the machine from the electrical power supply before attempting any
adjustment, repair or maintenance procedure (change of blades, depth-of-cut adjustment,
removal of wood dust, etc.).
2.
Always wear eye and ear protection as well as a respirator suitable for wood dust.
3.
Always use suitable dust collection system. Duct must be properly connected to dust extraction
port.
4.
Never operate the machine without first installing the side handle.
5.
Always use both hands to operate the machine.
6.
Small workpieces, panels, etc. must be securely fastened to work table before planing.
7.
Always check workpiece for nails, screws, stones or other embedded material. All foreign
material must be removed prior to planing.
8.
Keep all electrical power tools out of reach of children at all times.
9.
Do not allow power cord to lie on floor, in the way of passing personnel or the machine operator.
It will cause a trip hazard.
10.
Make sure the electrical outlet is properly grounded.
Never remove the grounding prong from the power plug!
11.
Use only grounded extension cords, minimum size: 14-gauge (AWG).
12.
Remove or confine loose hair, clothing and jewelry to avoid entanglement.
13.
Avoid a dangerous environment. Do not expose electrical equipment to rain. Do not use in
presence of flammable liquids or gases.
14.
Keep the area around the machine clean and free from scrap, sawdust, wood chips, oil and
grease to avoid the danger of slipping.
15.
Use only sharp and flawless original Hoffmann carbide blades.
16.
Replace worn blades immediately. Always replace blades in sets of two.
17.
Check the machine upon receipt as well as before every use for improper functioning and worn
or damaged parts. Make sure the blades are securely installed.
18.
Always check the proper function of the cutter head guard before operating the machine. Never
operate this machine with damaged or missing blade guard!
19.
Broken or defective parts must not be used until replaced or repaired by a qualified technician.
20.
When interrupting work or upon leaving the area, machine must be disconnected to avoid
unauthorized operation.
21.
Only trained and qualified personnel must be allowed to use machine.
22.
Only original Hoffmann replacement parts must be used to rebuild machine.
